J2 Lasher GMP

The model J2 Cable Lasher is used to lash a single aerial cable or numerous cables to a supporting strand or to an existing lashed cable with stainless steel lashing wire.

• Will lash any single or multiple aerial cables up to 3 in. (76mm) diameter across on any suspension strand from 1/4 in. (6mm) to 7/16 in. (11mm).

• Consists of a rotating drum supported on a carriage that provides the mounting for a driving mechanism, cable Lifters, cable, and strand rollers.

• Each of the two recessed magazines will hold a 1200 ft. coil of .045 in. (365m of 1.1mm wire) lashing wire. The lashing wire is fully recessed and covered by a gate.

• Features a fast setup procedure, quick coil loading, and automatic drum lock for easy span transfers and smooth forward travel.

• J2 Lashers make overlashing easy. Just push down on the strand roller knob, rotate it a quarter turn, and you can lash additional cables together on previously lashed cable.

• Positive internal gear to gear mechanism has no chains or belts to stretch, slip, or break.

• Constructed with heat-treated, plated Steel, stainless Steel, brass, and aluminum components. Contains sealed and oilless bearings to minimize maintenance and assure durability.

• Pre-drilled and tapped at the factory for Mounting of the Lasher Guard or “halo”. For use when Lashing in overgrown areas.

• The J2 and every GMP lasher is fully serviceable to “good-as-new” specifications at our factory and at factory-trained service locations around the globe.

• The lasher is furnished with a rugged, lightweight storage chest with corrosion-resistant hardware, recessed latches, and a moisture-proof, tongue-in-groove design for maximum protection when not in use.

• Supplied with a 6 ft. bridle rope assembly and snap hooks, and an information and operation manual.